William Paulsen

Lives in New York, New York United States Born on April 18, 1991 Male
William Paulsen
Categories

May 6, 2017 By:
One of the most unsightly things in a home is a sagging floor. This is common in many homes where the wooden floors have been affected by different adverse environmental conditions thus leading to sagging floors. This might only be bad because it is not attractive to look at. However, in some cases, these sagging floors could affect the foundation of the walls which then also affects the roof. The situation cannot be ignored and needs to be rectified. To rectify this and restore the structural integrity of the house, you need lumber that is used for construction and a screw jack. Making Preparations The first thing you need to do is to locate the sagging part of the floor. You need to identify the lowest point on the floor. To do this, rest a marble on the floor. It will roll and stop at the lowest point. The next step is to note exactly where this area lies in the basement or the crawl space, depending on what your house has. The next part is to prepare the timber that you are going to use. Cut 2 by 6 beams of lumber. Ensure that it is long enough to cover the area of the sagging floor. You do not need to cover the entire length. Proceed to cut two more lengths of the lumber that are about half the length of what you cut in the beginning. Using 16d nails, nail each set of the 2 by 6 beams of lumber. Ensure that your nails span about 12 inches for the interval on the length of each set of beaks. Now nail all of the sets together. This will form a 2 by 6 riser board using the beams. Rectifying the Sagging Now you get to raise the floor using a best floor jack in order to stop it from sagging. Take your floor jack and place it in the crawl space where your floor is sagging. Near the worm thread screw, at the jack’s top is a hole into which you need to slide the steel pipe into. Now turn the screw clockwise using the handle so as to raise the jack. This should continue until it is about a foot higher than the floor joists above. Now place the 2 by 6 riser assembly that you prepared and place it on the floor jack’s crown. Secure this riser assembly through the nailing holes provided on the boards. After this, continue turning the handle to create a raising motion until the riser assembly is at the same level as the floor joists. At this point, you need to nail this assembly onto the floor joists. This process has to continue as you move outwards. Remember that you started at the lowest point of the sagging floor. Therefore work outwards under the same directions: lifting and nailing the riser assembly as it makes contact with the floor joists. Stop the process once you have managed to level out the floor. For more Information Check Here Best Floor Jack