Troubleshooting a broken bleeder valve

Troubleshooting a broken bleeder valve A bleeder valve is used to release air from forced fluid in a motor vehicle. The procedure generally called as bleeding the brakes permits brake pedals to work perfectly. Bleeder valves can simply break when carrying out repairs on different parts of the braking system. Also closing and opening the valve can bring about wear and tear and break the control device. Other cause of damage to the part contains driving and braking too forcefully，KP-LOK bleed valve. Troubleshooting bleeder valves A general sing that there might an issue in the breaking system is when the brake pedal feels spongy and soft. For it to work rightly, it should be firm. In this case, take a look at the bleeder valves to check if they are in best condition, Remove the bleeder valves Determine which wheel has an issue with its bleeder valve, loosen lug nuts and remove it from the tire iron. Use a jack to lift the vehicle and ensure it is well supported. Release the wheel by pulling the lug nuts. Pull the caliper out of the rotor and launch the calipers. This should naked the bleeder valve. Inspect the bleeder valve If the bleeder valve is broken than it is important to change it with a new one. Get a blowtorch and gently heat the valve for about 13 seconds. Pass the torch from single side to the other to heat it evenly. Put the caliper in a bowl of chill water and leave it for a few seconds. Use a screwdriver to loosen the bleeder valve, and dislodge it from place. Change it with a new one and ensure it has the best fitting. Correct the stripped bleeder valve A stripped bleeder valve can bring about issues when changing or installing brake pads and also effect tasks such as replacing brake fluid. In this case, it is important to open up bleeder valves when changing break pads so as to stop brake fluid from flowing back to the brake lines which can bring about serious issues. Another factor why a bleeder valve should be opened up is that it makes it simpler to bleeder brake lines and it permits the old fluid to flow out as it is needed. To right the issue, place the stripped bleeder valve and heat it with a blow torch for about thirty seconds. Immerse the whole caliper in a bucket of water and remove it after half a minute. Use screw driver to gently get rid of the bleeder valve from its place. Ensure that new part has the right fitting and standard. Tips Before driving the vehicle, check the situations of the brakes by starting the engine and pumping the brakes. For the braking system to job rightly, they should feel firm. Once you have everything back into location you need to take your vehicle for a test drive. After you have done this come back and check the vehicle for any issues or leaks.